upon reading a forum I went in and modified the ratio and it gave me a huge degree of difference that was not desirable. I modified the AZ/ALT percentage with no result. I have tried many configurations, manually set location and timezone, accurate time, trained drives, testes motors and everything checked out fine. ![]() ![]() The problem I am encountering is that the alignment does not even come close to the target star! Also, i tried the 2-star alignment, i end up having to adjust the speed to accommodate the gap and it comes up with "alignment failed" The mount i have is an AZ/ALT mount, it is overshooting azimuth and undershooting altitude. Seemed like a good deal compared to my current "fine tune knob" scope. I picked up a Meade DS-114AT scope on craiglist for dirt cheap. I cannot setup the alignment on the Meade Autostar 494 for the life of me. ![]() I have a problem that may require some expertise as I am relatively new to computerized controllers. Hello all, I am brand new to this forum, I have read a great deal and most of the information came from this site.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |